I have a dolphin Active 30 and the app says there is an error. The cleaner is running and working.
"Error 1: DC in voltage"
"Error 1: DC in voltage"
Dolphin Active 30 Controller App Shows Problem
- Thread starter jerseyrails
- Start date
- Jul 21, 2013
- 65,414
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
If you have a multimeter I would do these checks and see if you have a power supply problem.
www.inyopools.com
How to Troubleshoot a Dolphin Pool Cleaner - INYOPools.com
This guide shows you how to troubleshoot the electrical circuits of the Maytronics Dolphin Pool Cleaners
www.inyopools.com
So it works if I put it in manual drive on the app. But on automatic mode, it runs for about five minutes then stops cleaning until I cycle the power.
Found the problem was the impeller had some dead stuff wrapped around it. Once I cleaned it and put it back in the water, it's worked fine. I've cycled it a few times today, it's doing its job as expected.
