I want to add some electronics out at the equipment pad, and will need to plug in the power adapter somewhere. I was thinking about adding a DIN outlet to the rail inside my Compool enclosure, which should house everything nicely.
Has anyone done this, and if so, have you had any issues?
On a similar note on the low voltage side, the Compool transformers feed 10, 18, and 24 VAC to the EasyTouch control board. Is it feasible to tap into these if those voltages might be needed in the future, provided of course any future loads don't create a significant voltage drop at the board?
-DBB
Has anyone done this, and if so, have you had any issues?
On a similar note on the low voltage side, the Compool transformers feed 10, 18, and 24 VAC to the EasyTouch control board. Is it feasible to tap into these if those voltages might be needed in the future, provided of course any future loads don't create a significant voltage drop at the board?
-DBB