Diagnosing issue with Aquarite control pad

Jump to latest Follow Reply
P

Patflemming

Member
Apr 5, 2024
7
Toronto Canada
I've already searched through the forum and found similar issues but nothing quite the same as mine. I'm hoping for some help diagnosing an issue with my Acquarite control pad.

I've just opened my pool today and when switching the SWG to auto, there is a click noise, following by another click noise about 5 seconds later. After the second click, the power and generating green lights turn off. At that point there are no lights on at all. The displays always shows 3000.

I took a picture of the board and wiring.
Any idea whats happening? Is the control pad, or the cell? Could the cold water have anything to do with this?
20240510_164729.jpg
 
Patflemming said:
Can you tell from the picture that the thermistor is cracked? Is it that diagonal line running through it?
Click to expand...

The red lines definitely look like cracks. The yellow line may be a crack.

1715386439904.png
Patflemming said:
What would burnt solder pads indicate?
Click to expand...

That is from the thermistor overheating which causes the cracking.

Running high salt levels (over 3,000 ppm), causes high amps, which causes heat in components and the board, which burns up components.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply