My pool was installed and I programmed the omnilogic last year, I did a fantastic job learning it and helping others get theirs running...... but I ran into a problem that I had solved last year and didn't expect to have to do this again. I found an answer on here I think, about how to set a Hayward heatpro heatpump to be controlled by the omnilogic. I had it working fine last year, but after shutting the pool down for the winter apparently the heat pump loses the settings for automation, and I don't remember exactly how I configured the heat pump to be controlled. I have been searching and searching for the thread that had the answer in it, but I cant find it. The steps to do it are a lot more complicated than one would think, Can anyone help?/???