Bottom rails sliding out of upright connectors

[hausmann]

Heyo, wasn't sure how to word this. I have a picture.

Setting up our Sharkline Reprieve AGP. After getting the wall placed and building the cove, one of the upright bases looks like this. Others are too far in, passed the dimples, most are spot on - this is the worst offender. The walls are very close to absolute level, I spent an exorbitant of time making sure, lol. It's a perfect circle now, some parts of the wall were off by an inch or two before we put the cove in, maybe that's why this issue cropped up.

There is no water or liner in the pool. I am going to try and budge the rails with a soft mallet and get them as close to centered as I can. I couldn't find much on this issue. Is it something to actually worry about?

Thanks!

 

[Texas Splash]

Hello! I'm guessing by now you made everything work? Got a bigger hammer? Ha. Or do you still need some feedback?

 

[hausmann]

Hi! Sorry for the long delay on updating this post. I couldn't get the rails to budge and the manual does not mention anything about how far apart the rails should sit in the bottom plates, so I just went with it. I left the uprights off for about a week to make sure, the rails hadn't moved at all. So it's been fully assembled since then and very solid.