I know this is an old post, but does anyone have the pin information on the t-cell itself? Where on the molex is pin 1, pin 2, etc?
AquaRite T-Cell Cable Pin Information
- Thread starter 20Limited
- Start date
- May 3, 2007
- 18,185
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
Welcome to the forum!
Holding the plug vertically with the cord going down and looking at the connection points. 1 is top left, 2 is top right, 3 is second down left and so on with 9 being lower left and 10 being lower right.[51]
www.troublefreepool.com
What is not shown on the this diagram is that Hayward now uses pins 7 & 8 which are shorted on some current Hayward cells to detect an OEM cell with newer controllers.
Holding the plug vertically with the cord going down and looking at the connection points. 1 is top left, 2 is top right, 3 is second down left and so on with 9 being lower left and 10 being lower right.[51]
- 1) Black - Power to cell
- 2) White - Power to cell
- 3) Black - Power to cell
- 4) White - Power to cell
- 5) Brown - Not used
- 6) Red - Goes to thermistor
- 7) Orange - OEM Cell Sense
- 8) Yellow - OEM Cell Sense
- 9) Green - Not used
- 10) Blue - Goes to thermistor.
Hayward Aquarite SWG - Further Reading
www.troublefreepool.com
What is not shown on the this diagram is that Hayward now uses pins 7 & 8 which are shorted on some current Hayward cells to detect an OEM cell with newer controllers.
Similar threads
