AquaRite amps are zero on Salt Cell

[MLaird]

My aquaRite salt cell T15 looks like it is working lt light and the generator lights are on but i checked the volts and amps and it is showing 31 volts and 0 amps. The dial is set to 90% or switched to Super Chlorinate. I turn the dial up and down and it doesn't change the Amp setting of Zero.
if I turn the button from off to back on. After a few seconds it turns on and alarms normal. After about 20min. The Amp go to zero and instant salt reading is zero

 

[JamesW]

Output is scaled back to 20% at 60° F and output stops at 50° F.

.9 x .2 x 180 = 32 minutes.

 

[MLaird]

Thank you. So my current temp is 58°F. Would this explain the Amps showing zero while volts are at 30? I was thinking I might have to replace my board. Hope not...

 

[JamesW]

When not generating, the voltage is about 30 to 32 volts dc.

When generating, the voltage drops about 1 volt per amp of current.

So, what you're seeing is normal.