Aqua Plus problem

[seturner]

Hello,

I have an Goldline Aqua Plus control that is not generating chlorine.

I have had several issues in the past, all involving broken solder joints. I had the board repaired early this Summer, as it had the "No Cell Power 2" error message. It has been working fine until a week ago, now I get "very low salt" and the chlorinator will not turn on.

On the diagnostics menu, when I cycle the generator on, I am getting 31.37V, about .15A and instant salt reading of 0000. The voltage and amp reading both have a minus sign in front of them as well.

There is one other error, water sensor says it is open circuit. Flow switch shows flow though.
*UPDATE* Found a loose wire, water sensor works fine now. Chlorinator still does not.

Any ideas on what it could be?

I cleaned the salt cell about 3 weeks ago using the stand to hold it vertical and seal off bottom, but it has worked fine for a couple of weeks afterward.

Thanks

 

[BasicTek]

How old is the cell? What did you clean it with (scraping or acid)? What's the instant salt reading now? Have you tested how much salt there is with a test kit or strips?

 

[seturner]

How old is the cell? About 6 yearsWhat did you clean it with (scraping or acid)? ACID the instant salt reading now?0000 Have you tested how much salt there is with a test kit or strips?Not yet. It was 3300 instant before it stopped

Answers in red above. Thanks

 

[JamesW]

Probably a bad solder joint.

AquaRite Problem not found elsewhere display reading volts and temp, but not amps or

 

[BasicTek]

Can you get the cell tested at a pool store?