Aqua Plus - Check System, No Cell Power 2

Cpa757va

New member
Dec 13, 2019
1
Virginia
We have a salt water pool with a Hayward pump and a T-Cell-15 TurboCell Salt Chlorination Cell. And as of yesterday we are seeing the Check System / No Cell Power 2, Chlorinator Off / No Cell Power messages on both the unit and on our Aqua Pod Handheld Remote Control for Pro Logic and Aqua Logic.
 
Last edited by a moderator:

mpk1970

Well-known member
May 14, 2013
77
It could be your cell. I had a control panel go out---looked inside and could see the burned out area. Then a year later had another issue with salt cell light & inspect cell. Ended up panel was fine but was
salt cell failure.
 

chlorinatorpro

In The Industry
Feb 16, 2016
103
CA
Usually this issue is the K1 relay on your board that may have a hairline crack on one of the solder points (on back of board). Simply lay a fresh coat of solder on each of the points to resolve.