Adjusting AquaPure 1400 pcm salinity

[knjpool]

In reference to this old thread. They requested that i start a new one.

Recalibrating Jandy Aquapure

I just installed a Jandy Aquapure SWG, got all my levels right and just turned it on today. The salt sensor on the Aquapure is consistently 300ppm higher than the Taylor K-1766. When I tried to follow the instructions to calibrate it, I ran into a snag. Everything I read says to hold the...

www.troublefreepool.com

I followed the procedure to adjust salt ppm in Jandy Aquapure, got all the beeps but the arrows did nothing.

Adjustment reason: I adjusted it several years ago in 2020 to +300, but now i need to reverse that to -300.

 

[HermanTX]

In reference to this old thread. They requested that i start a new one.

Recalibrating Jandy Aquapure

I just installed a Jandy Aquapure SWG, got all my levels right and just turned it on today. The salt sensor on the Aquapure is consistently 300ppm higher than the Taylor K-1766. When I tried to follow the instructions to calibrate it, I ran into a snag. Everything I read says to hold the...

www.troublefreepool.com

I followed the procedure to adjust salt ppm in Jandy Aquapure, got all the beeps but the arrows did nothing.

Adjustment reason: I adjusted it several years ago in 2020 to +300, but now i need to reverse that to -300.

I would turn off power to the whole iAquaLink and then check if it adjusted. Sometimes the system needs a hard reset.