I read that I'm supposed to add the chemicals to my hotsprings hot tub in the filter compartment. However, when I just added dichlor and ph down and ran the clean cycle, when it was over, I could still see some of the chemicals on top of the filters. Is there a better way to add the chemicals so they dissolve more evenly?
Adding chemicals to HotSprings Limelight Flair
- Thread starter lagreca
- Start date
JoeSelf
Gold Supporter
I pour or dump with the jets running into the center area of my tub, away from the sides. I then run the jets for a minimum of 3 minutes.
- Jun 1, 2018
- 16,012
- Pool Size
- 26000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
Thats a quick way to bleach out your filter and filter area. My manufacturer says the same thing though- 
Infront of a return jet , away from the wall with jets running like as Joe mentioned is the safest way to add chems to the spa.
Infront of a return jet , away from the wall with jets running like as Joe mentioned is the safest way to add chems to the spa.