Today was the first visit to a new client whose pool is a few months old. Upon testing water chemistry, the pool had -0- chlorine even though their Pro Logic/Turbo Cell installation was set at 60% output and the filter pump is programmed to run 8 hours per day. The diagnostic menu on the control says the flow is okay and salt is at 3100 ppm. Water temp at 59º. When looking at the SWG, the installation doesn't look right to me. A pic is attached.
All of the installed Turbo Cell's I've encountered have had the water go through the flow sensor, then through the tapered end of the Turbo Cell, and out the "blunt" end. In this case, it is the opposite. Water flows through the blunt end of the Turbo Cell, out the tapered end, then through the flow sensor, and then out the return lines. Does it matter which end the water flows through the cell as long as the flow switch is happy?
I really need the input of someone who has experience with these so that I can advise the client. Thanks for all your help!
All of the installed Turbo Cell's I've encountered have had the water go through the flow sensor, then through the tapered end of the Turbo Cell, and out the "blunt" end. In this case, it is the opposite. Water flows through the blunt end of the Turbo Cell, out the tapered end, then through the flow sensor, and then out the return lines. Does it matter which end the water flows through the cell as long as the flow switch is happy?
I really need the input of someone who has experience with these so that I can advise the client. Thanks for all your help!