Hi all. I recently bought a Intex above ground pool which came with a small paper filter/SWG combo. I decided to upgrade to a Sandfilter with Salt Water Generator combo unit (1600 gph, Model 20110). Here's my numbers done with a Taylor Text Kit. I've had the Boost system running for about 12 hours.
FC: 0
pH: 7.6
TA:60
CYA: 80
Salt: 3500ppm
My question is this new filter unit doesn't seem to be putting enough chlorine out. It has slowly gone down since I replaced the smaller unit with the bigger one. I tested water coming right out of return, it measured chlorine level at .5, I think it would be much higher coming out of return jet? I don't see many bubbles coming out of electrolyte cell, looks cloudyish (but water isn't).
I'm not getting any alarms or anything, just very little chlorine. Thanks for any input. Todd
FC: 0
pH: 7.6
TA:60
CYA: 80
Salt: 3500ppm
My question is this new filter unit doesn't seem to be putting enough chlorine out. It has slowly gone down since I replaced the smaller unit with the bigger one. I tested water coming right out of return, it measured chlorine level at .5, I think it would be much higher coming out of return jet? I don't see many bubbles coming out of electrolyte cell, looks cloudyish (but water isn't).
I'm not getting any alarms or anything, just very little chlorine. Thanks for any input. Todd