I am installing the stenner pump into a Tee fitting. The instructions say to wrap the male end of the injector with 2-3 wraps of plumbing tape. Then there's a pic that says do not use plumbing tape. Do you guys know if it matters? I'm talking about the injector fitting that goes into the return.
Also, it says to trim the end that will go into the pool plumbing as necessary, called the injection fitting quill. What would constitute necessary? I screwed the injection end into a 1/2" thread on the Tee fitting. So...
Those of you that have done this could you let me know if this is important or what you did? Thanks so much.
Matt
Also, it says to trim the end that will go into the pool plumbing as necessary, called the injection fitting quill. What would constitute necessary? I screwed the injection end into a 1/2" thread on the Tee fitting. So...
Those of you that have done this could you let me know if this is important or what you did? Thanks so much.
Matt