I have a variable speed pump for my main pump, but I want a booster pump to run my water features, deck jets, water slide, and four jets in the back of the buddy seats, they were here today hooking up all the plumbing and mentioned to me that they were using one skimmer for the booster pump and one skimmer for the main pump. I asked if they could just "T" off the main drain for the booster pump instead of dedicating a skimmer only to the booster pump. Reason being is that I am going to put actuators on all plumbing for the omnilogic to control and I really wanted both skimmers working when I have the main pump running, the main drain would still be running to both pumps, but the booster pump would pull from the main drain when the controller calls for the booster to be running. They seemed very confused by this and I am wondering if I am asking too much, there would be an actuator valve at that "T" for the main drain controlled by the omnilogic.