Below are my test results, this is more than a week after the pool builder put their chemicals in, which include stabilizer. I would assume these tests legit.
Test Result (Target)
FC: 1 (4)
PH: 8.2 (7.6)
TA: 80 (80)
CH: 225 (300)
CYA: 80 (75)
Salt: Salt call says 4450, AquaChek test strip #1 said 830, test strip #2 said 1550 (3700)
Water Temp: 79F
Air Temp: 91F
Big difference with the salt numbers - yesterday I turned my salt cell (IC40) to 0% because I saw that it was reading 4450ppm. Now the strips read super low but the EasyTouch system still shows high. A little confused. Thank you in advance.
Test Result (Target)
FC: 1 (4)
PH: 8.2 (7.6)
TA: 80 (80)
CH: 225 (300)
CYA: 80 (75)
Salt: Salt call says 4450, AquaChek test strip #1 said 830, test strip #2 said 1550 (3700)
Water Temp: 79F
Air Temp: 91F
Big difference with the salt numbers - yesterday I turned my salt cell (IC40) to 0% because I saw that it was reading 4450ppm. Now the strips read super low but the EasyTouch system still shows high. A little confused. Thank you in advance.