I purchased a CircuPool SI-30 Plus generator system. To be blunt, the installation instructions for the cell suck. The only thing that they stress is that the flow sensor be installed at least 12" from any elbows (it is a turbulence thing). The flow sensor isn't even marked for direction of flow. There is nothing in the directions about the installation of the cell itself.
Now, three questions:
1) There are no markings on the cell indication direction of flow. If you look into the ends, you can see plates on one end and a locator block (on the end with the cable) in the other. I assume that the internal sensors are on the cable end. Does it matter which end the water discharges from?
2) What is the proper orientation of the cell, horizontal, vertical, or does it matter?
3) If the orientation can be vertical, should the flow be up through the cell or down?
Now, three questions:
1) There are no markings on the cell indication direction of flow. If you look into the ends, you can see plates on one end and a locator block (on the end with the cable) in the other. I assume that the internal sensors are on the cable end. Does it matter which end the water discharges from?
2) What is the proper orientation of the cell, horizontal, vertical, or does it matter?
3) If the orientation can be vertical, should the flow be up through the cell or down?