Hello to all,
Our PB installed an auto-fill, but I am not sure if it is operating properly.
Based on the waterline should bisect our top-tile in half, it is now below that point. When I push down on the floating ball to simulate a much lower level of water, you hear the water come on, but the flow rate is no more than if an old tank on a toilet was leaking. Does this flow rate sound correct?
Are there any videos or something that I can on how a proper auto-fill valve should work?
Thank you very much,
tstex
Our PB installed an auto-fill, but I am not sure if it is operating properly.
Based on the waterline should bisect our top-tile in half, it is now below that point. When I push down on the floating ball to simulate a much lower level of water, you hear the water come on, but the flow rate is no more than if an old tank on a toilet was leaking. Does this flow rate sound correct?
Are there any videos or something that I can on how a proper auto-fill valve should work?
Thank you very much,
tstex