Ok so I have gotten back from vacation and am trying to get this salt system working right. The intellichlor is reading low but my aquacheck test strips say 3800ppm. I have reset the circuit for the intellichlor but nothing has happened. I also noticed that the light for the staus of the cell is not on but the green light for the life of the cell is on. What am I missing here? The intellichlor seems to be working I think???? My Ph is a tad on the high side(7.7ish) and I'm going to get MA to bring it down some. If some of my other chems are only off a little will it affect the intellichlor? I'm going to run a full set of numbers after I get my PH down my TA is off a little also and I have low CH so I'm bringing that up. My CYA needs to be rechecked so.... just wondering if it a mechanic issue or maybe mt chems need to be spot on to have the intellichlor to work right. Any suggestions other then a full set of numbers?