Yesterday's pumping cycle average salt readings (salt strip 3260):
7a=200 no generation - check salt, inspect cell on
8a=2100 no generation - check salt, inspect cell on
9a=2100 no generation - check salt, inspect cell on
10a=2100 no generation - check salt, inspect cell on
Move control box to off and immediately back to auto.
System restarts showing 2100 no generation - check salt, inspect cell on.
In less than two minutes, average reading jumps to 2900,
instant salinity 3700 and generating.
At the end of the 5 hr pump cycle (only 2 hrs generating), shows
3700 average salt level and 3900 instant salt level.
Today: (salt strip 3370)
7a=100 no generation - check salt, inspect cell on
8a=2000 no generation - check salt, inspect cell on
9a=2000 no generation - check salt, inspect cell on
10a=2000 no generation - check salt, inspect cell on
Move control box to off and immediately back to auto.
System restarts shows 2000 no generation - check salt, inspect cell on.
In less than two minutes, average reading jumps to 2900,
instant salinity 3700 and generating.
At the end of the 5 hr pump cycle, (only 2hrs generating) show
3200 average salt level and 3600 instant salt level.
Why is the average salt level changing so drastically in 24 hours?
The generator’s low salt readings prevent it from automatically starting,
which means I must force start it. Just don’t know why. Never had to do
anything like this in the past 7 years. Will give Hayward a call tomorrow
and see what they say.