Need a little advice doing the plumbing work to add my heat pump. I attached some photos and drew out a 2":1" layout on graphing paper.
First image below is simple the current layout on my pad.
Second image is the current layout on graphing paper.
Last image is my proposed layout.
It was recommended I turn my heat pump so the inlet/outlet are facing my existing equipment. Would help cut down on 90s and PVC in general. Great idea, but. . . There's no way I can get everything to fit (The bypass, valves and SWG.) Just too tight.
So am I missing anything simple? Any recommendations?
First image below is simple the current layout on my pad.
Second image is the current layout on graphing paper.
Last image is my proposed layout.
It was recommended I turn my heat pump so the inlet/outlet are facing my existing equipment. Would help cut down on 90s and PVC in general. Great idea, but. . . There's no way I can get everything to fit (The bypass, valves and SWG.) Just too tight.
So am I missing anything simple? Any recommendations?