Hi all, new here. Been trying to figure some things out, but not much time to do so. I have a Ø18'x52" ultra frame SWG setup with the stock pump. I'm in Wis. so the water stays cold until mid july. I did see a video on making a solar heater for it, which is easy enough to do.
My questions have to do with:
1) trying to get standard plumbing fittings/pipe (Ø1.5") to fit up with the inlet/outlets from the pool. I did see some examples, but I'm not sure of the best way to do it, what glue to use, etc.... economical also.
2) I do see a new pump/filter setup maybe next year. Any recommendations? do you have to use certain ones with the SWG setups?
Thanks for any info you can provide.
My questions have to do with:
1) trying to get standard plumbing fittings/pipe (Ø1.5") to fit up with the inlet/outlets from the pool. I did see some examples, but I'm not sure of the best way to do it, what glue to use, etc.... economical also.
2) I do see a new pump/filter setup maybe next year. Any recommendations? do you have to use certain ones with the SWG setups?
Thanks for any info you can provide.