I have been deep into my aqua logic salt system. My cell (Turbo 15) is clean and is 2 years old and I have taken to pool store twice to have tested and passed both times. I know I have around 3,200-3,400 salt in the water but readings are 2,200-2,700 most of the time. I can trick system by clicking on diag button each day and pushing plus and then minus and get reading up to 2,900 most of the time, then I save that setting and all is fine, until the next day, and it says low salt again. My thinking is I could get actual salt level up high enough that the board would finally ready 3,000 or so and keep running on its own, but not having much success with this.
I am thinking either my cell is bad or there is another part that reads the salt level other than cell? Just dont want to replace cell and find out I have same issue again. I have cleaned cell over and over and filters are clean.
I called Hayward, no help, I have asked every pool store I can find, no help, and no pool guy seems to know anything. Somebody has to be a wizard on this system.
I am thinking either my cell is bad or there is another part that reads the salt level other than cell? Just dont want to replace cell and find out I have same issue again. I have cleaned cell over and over and filters are clean.
I called Hayward, no help, I have asked every pool store I can find, no help, and no pool guy seems to know anything. Somebody has to be a wizard on this system.