I spent about 6 hours yesterday plumbing new filter and pump/motor. At the end was excited to fire it up and check for leaks etc. However, I flipped the switch to the pump and nothing. Not even a green light on the VS panel or a fault light. SO.. I open up connection panel on motor and verify 120/118 line voltage to the connection lugs A and B and that insulated ground is connected. The bonding wire to pool is connected as well. I held Start button on VS panel for 10 seconds along with a couple others too. I find it hard to believe that the thing is completely dead new out of the box. Am I missing something simple? Looking for ideas from the more experienced before I have to deal with warranty people at Pentair.