Hi all. I've searched the forum and haven't seen my question asked yet.
I have a 16*48" Intex Ultra going into its second season. The ground was within an inch at the end of the season last year but I have redone it this year.
I have placed 4*8*16" pavers and have them all level and sticking approximately 3" above the ground. I have laid down crusher run into the entire circle and am getting ready to compact to make the entire surface uniform. I like to use the 3/4" foam underneath as it provides a very soft feel (and somewhat protection to tailbones). However, I am trying to make this visually appealling as well and do not want to put the legs of the pool on top of the foam.
I was going to leave the pavers 3/4" high and run the foam to that but am afraid of having the liner rub and potentially cause a hole.
Is there any drawback to laying the foam and leaving it just short of the legs? This would essentially leave the legs 3/4" lower than the liner.
Thanks in advance.
I have a 16*48" Intex Ultra going into its second season. The ground was within an inch at the end of the season last year but I have redone it this year.
I have placed 4*8*16" pavers and have them all level and sticking approximately 3" above the ground. I have laid down crusher run into the entire circle and am getting ready to compact to make the entire surface uniform. I like to use the 3/4" foam underneath as it provides a very soft feel (and somewhat protection to tailbones). However, I am trying to make this visually appealling as well and do not want to put the legs of the pool on top of the foam.
I was going to leave the pavers 3/4" high and run the foam to that but am afraid of having the liner rub and potentially cause a hole.
Is there any drawback to laying the foam and leaving it just short of the legs? This would essentially leave the legs 3/4" lower than the liner.
Thanks in advance.