Hello everyone. I'm in the same boat as several I see on here: I bought a house recently with an IG SWG pool. I started out going to the local pool store, bought a bunch of chemicals, and got my pool back to 'blue/clear'. But the water is cloudy about 2-3 feet down. It's been at this state for about a week now. I've backwashed and rinsed the sand filter a few times during this time.
I found this website, bought the TF-100 kit, and just did my first test. Below are my results:
FC - 4
CC - 1
pH - 7.5
TA - 120
CH - 125
CYA - 70
My SWG says there is currently a 3600 ppm salt level, and I have my output % set to about 60.
From what I can tell by reading the Pool School, my TA is high, and my FC may be too low. Is that correct, or am I missing something?
Any and all advice to get my pool balanced and cleared up would be very much appreciated!
I found this website, bought the TF-100 kit, and just did my first test. Below are my results:
FC - 4
CC - 1
pH - 7.5
TA - 120
CH - 125
CYA - 70
My SWG says there is currently a 3600 ppm salt level, and I have my output % set to about 60.
From what I can tell by reading the Pool School, my TA is high, and my FC may be too low. Is that correct, or am I missing something?
Any and all advice to get my pool balanced and cleared up would be very much appreciated!