We had a good pressure test before gunite. But before filling in perimeter ditches, we pressure tested again and discovered a leak at one of the spa jets. Gunite company is very reputable but unfortunately the nozzle guy must have run into the extending return pipe to hard (6' ID). Looks like a pin hole right above a Tee. But is it the only one?
PB wants to epoxy the hole, I think it should be cut out and replaced. Also, how should concrete be replaced without having a "cold joint"? Re-shot with gunite?
Any ideas? Thanks for any advice!!
Currently
Rebar/plumbing
Leak
Jackhammered
Sent from my iPhone using Tapatalk
PB wants to epoxy the hole, I think it should be cut out and replaced. Also, how should concrete be replaced without having a "cold joint"? Re-shot with gunite?
Any ideas? Thanks for any advice!!
Currently
Rebar/plumbing
Leak
Jackhammered
Sent from my iPhone using Tapatalk