Ok here's a bit of an oddball question, although I see it was asked once before a while back (without an answer.)
Last season I built my own automation controller to better micro-manage and track my solar setup. I am now trying to design/build a circuit board to make it easier to build similar Arduino or Raspberry Pi based systems.
I am looking to find a compatible connector for the Jandy/Goldine/Hayward automated valves. It's that little plastic bit on the end of the wire to connect the three wires to the controller. Does anyone know what that type of connector is called, have a part #, or info that could lead to a compatible part #?
Thank you for any assistance.
Last season I built my own automation controller to better micro-manage and track my solar setup. I am now trying to design/build a circuit board to make it easier to build similar Arduino or Raspberry Pi based systems.
I am looking to find a compatible connector for the Jandy/Goldine/Hayward automated valves. It's that little plastic bit on the end of the wire to connect the three wires to the controller. Does anyone know what that type of connector is called, have a part #, or info that could lead to a compatible part #?
Thank you for any assistance.