Hi
SunTouch controller ;
I just put a new sensor for water , being in Australia I want it to display Celsius but as with the previous sensor from when that was new when I change it over it shows the pool temp as 255C when I set it to show Celsius , I can only adjust it down to 175C , I did cut the pool temp wire down to about 8ft would this change the resistance ? .
I don't have a multimeter about time I guess to get one .
Left as Fahrenheit the values show correctly .
I guess it more annoying than crippling .... but why would F temps show ok but not C temps .
Also the old sensor had split vertically down the bulb what would cause this ? . The Solar system had been out of use for 18mths because of the delay in getting a new roof .
Thanks
dave
Ok update i just went out to see something now when i put it into Celsius mode I get ERROR on both the solar and water sensors , I have to go right but to the start of the menus go to Advance the reset to Fahrenheit and the temps are normal again . grrrrrrr
SunTouch controller ;
I just put a new sensor for water , being in Australia I want it to display Celsius but as with the previous sensor from when that was new when I change it over it shows the pool temp as 255C when I set it to show Celsius , I can only adjust it down to 175C , I did cut the pool temp wire down to about 8ft would this change the resistance ? .
I don't have a multimeter about time I guess to get one .
Left as Fahrenheit the values show correctly .
I guess it more annoying than crippling .... but why would F temps show ok but not C temps .
Also the old sensor had split vertically down the bulb what would cause this ? . The Solar system had been out of use for 18mths because of the delay in getting a new roof .
Thanks
dave
Ok update i just went out to see something now when i put it into Celsius mode I get ERROR on both the solar and water sensors , I have to go right but to the start of the menus go to Advance the reset to Fahrenheit and the temps are normal again . grrrrrrr