Okay, finally got a chance this weekend to run a full test using my new TF-100 test kit. Have been using a Stanley kit supplied by the PB since July, but wanted to make sure I was using the good stuff. Here's my numbers:
FC - 14! (Have dialed back the pump run time as of this to 2 hours a day, will re-check tomorrow)
CC - 0
PH - 7.8 (Has been worse, this new pool has been an acid sucker!)
TA - 160
CH - 360
CYA - 0/did not test (Have not added any yet, want to get this chlorine level fixed first)
No Borates yet, but when I have a handle on balance I intend to add
NaCL - 2800 ppm (Pool control monitor reads 3200 ppm, but I trust the test kit)
Thanks to all of the good advice on this forum I believe you've given me the data I need to move this in the right direction, but I'm always open to comments or suggestions!
-Dan
FC - 14! (Have dialed back the pump run time as of this to 2 hours a day, will re-check tomorrow)
CC - 0
PH - 7.8 (Has been worse, this new pool has been an acid sucker!)
TA - 160
CH - 360
CYA - 0/did not test (Have not added any yet, want to get this chlorine level fixed first)
No Borates yet, but when I have a handle on balance I intend to add
NaCL - 2800 ppm (Pool control monitor reads 3200 ppm, but I trust the test kit)
Thanks to all of the good advice on this forum I believe you've given me the data I need to move this in the right direction, but I'm always open to comments or suggestions!
-Dan