I had another thread on wiring the Dig-220 with a 2-speed pump and got good feedback. I plan on using the pump relay to control high/low speed with the autopilot but using a timer to control on/off periods. My questions deal with how the autopolit controls the programing.
I want to set the timer to run the on/off cycles in low and then just use the autopilot to change pump speed manualy for when I need to vaccum.
To get to this I assume I just set the autopilot as using an exteneral timer in the intial set-up menu. Would that take care of everything? Or am I just better off not using pump relay and installing a seperate switch to control pump speeds?
There installing liner today so any help is greatly appreciated.
Thanks
Daren
I want to set the timer to run the on/off cycles in low and then just use the autopilot to change pump speed manualy for when I need to vaccum.
To get to this I assume I just set the autopilot as using an exteneral timer in the intial set-up menu. Would that take care of everything? Or am I just better off not using pump relay and installing a seperate switch to control pump speeds?
There installing liner today so any help is greatly appreciated.
Thanks
Daren