I am hoping someone can help me here. I have a Pebble Tec pool that sat for two weeks without filtration because my pool motor died. The pool turned green which I expected. The new pump was installed and I began shocking it and treating it with Algaecide. It cleared up the water but the algae is stuck to the pool surface. I scrubbed a small section with a wire brush and it helped a little bit but the entire surface is covered (25,000 gallons). I am thinking I have to drain the pool and maybe pressure wash it. Are there any chemicals to help remove this build up so I don't have to drain it? I don't even know if pressure washing is good for Pebble Tec...
Thanks for any suggestions,
Janice
Thanks for any suggestions,
Janice