We came back from vacation and the pool was turning green. I opened the control panel and removed the face plate and noticed that the current limiter was burnt at the contact pad. I ordered the current limiter through digikey and decided to solder a new limiter on myself. Well the power and generate light comes on for a couple seconds and shuts off.
1. Did I just do a bad soldering job?
2. The contact pad on right side is coming off board. This can't be good. It was tough getting that off and ended up tearing up the contact pad. Can it be fixed?
3. A replacement board is about $175 on Amazon. Should I go this route?
Patrick
1. Did I just do a bad soldering job?
2. The contact pad on right side is coming off board. This can't be good. It was tough getting that off and ended up tearing up the contact pad. Can it be fixed?
3. A replacement board is about $175 on Amazon. Should I go this route?
Patrick