I have 2 inch plumbing. Everywhere. I am installing 4x pentair deck jets II that each have a 3/4 inch pipe fitting. My plan is to build a 2 inch plumbing loop with 4x "T"s coming off of it. Each of the Ts will be followed by a 3/4 inch valve to control flow to each jet.
Problem. I can't seem to find Ts that reduce 2 inches into 3/4 inch. I know I can buy reducers, but I'd have to buy lots of them, ie 2 inch to 1.5 inch to 1 inch to 3/4 inch. Times 4!!!
Am I thinking about this correctly? Is there an easier way to build this?
Thanks for the advice.
:?:
Problem. I can't seem to find Ts that reduce 2 inches into 3/4 inch. I know I can buy reducers, but I'd have to buy lots of them, ie 2 inch to 1.5 inch to 1 inch to 3/4 inch. Times 4!!!
Am I thinking about this correctly? Is there an easier way to build this?
Thanks for the advice.
:?: