- Jul 10, 2012
- 54
- Pool Size
- 16800
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
I picked up an Intex 2650 sand filter for my AGP a few months ago. Its been running well, but this morning I realized its running with really low flow. I turned the pump off, and move it to recirculate and turned it back on to see if it was the pump or something else. The flow almost doubled (used unscientific method of feeling the inbound flow with my hand). I turned the pump off again, move the valve to filter, turn it on again and the flow cut way down again. My pump pressure is a bit low maybe 8 psi (usually runs closer to 10). Should I backwash this thing? What am I missing?
Thanks!
--Jonathan
Thanks!
--Jonathan