:| I hope someone is out there who can help. This project has been a nightmare from the word "go". At any rate, we finally got our wall up and unrolled our liner and it had a split in the seam. Fortunately, we were able to find a place that was still open 45 minutes away (on a Saturday evening) and got a new liner. Tried installing Saturday night so that the pool would not be empty. Spent hours and could not get it over the one edge (overlap). Took it all down yesterday, folded in the sides and pulled the bottom oval out to all edges and then attempted to rehang. It looked good at first (better anyway) and we had all edges up, but it still pulls on one side. We thought that maybe if we started filling it, it would fix itself. It didn't. Now the side of the pool where it is taught is caving inwards. I can't put more water in because it will collapse inwards and I can't empty it because we're expecting wind gusts of 14 mph this afternoon that have thus far taken the pool out of it's tracks on numerous occasions. Do I need to take down the whole pool and start from scratch? My husband and I have thus far spent over 50 hours just trying to install the pool. I'm trying to upload some images now.