Im going to have 4 deck jets, 2 on each long side of the pool.
The install instructions say to "create an equal pressure loop". Im not quite sure what that is.
Would it work if I ran from the pad a 2" pipe down one side, a T dropping it down to 3/4" and up to deck level, continue on around the entire pool perimeter doing this and at the last jet run it past the T for about a foot and cap it.
Would it be better to have 2 2" feeders coming from the pad, one down each side?
The install instructions say to "create an equal pressure loop". Im not quite sure what that is.
Would it work if I ran from the pad a 2" pipe down one side, a T dropping it down to 3/4" and up to deck level, continue on around the entire pool perimeter doing this and at the last jet run it past the T for about a foot and cap it.
Would it be better to have 2 2" feeders coming from the pad, one down each side?