OK, so I swapped out my 10 year old Jandy HP Plus pump, with the new VS-Flo Pro. Everything went well, plumbing, electrical, etc. I also have a Jandy RS-8 system, which I upgraded to the new IAqualink, which required the new PCB. All wiring was hooked from old to new exactly. Here is the issue:
The new pump works with the included variable speed controller, although, the Aqualink center needs to be in "service" mode, and I must manually push the "pump" button to get power to the pumps controller, which I think is an issue and I cant figure out why. You would think the controller which came with the Flo Pro would control the pump with the power center setting on "auto."
When I hook the low voltage wiring from the new pump to the RS 8 power center, it will not turn on the new Jandy pump. I tried every dip switch combination, shutting all power between tries to re-set the system.
I need some ideas on what else it could be as Im sitting here wondering what I am missing.
Thanks in advance.
Ken
The new pump works with the included variable speed controller, although, the Aqualink center needs to be in "service" mode, and I must manually push the "pump" button to get power to the pumps controller, which I think is an issue and I cant figure out why. You would think the controller which came with the Flo Pro would control the pump with the power center setting on "auto."
When I hook the low voltage wiring from the new pump to the RS 8 power center, it will not turn on the new Jandy pump. I tried every dip switch combination, shutting all power between tries to re-set the system.
I need some ideas on what else it could be as Im sitting here wondering what I am missing.
Thanks in advance.
Ken