I see a lot of issues VSP pumps having air at a lower RPM. Would that also affect a 2 speed pump. it has an air bubble constantly at the top. I just replaced the motor on my duraglass with a 2 speed.
Mine does too. Does not lose prime when off and do not find any air in the filter. Seems normal.
I have left is on low for weeks and the bubble gets bigger and bigger, but does not get into the filter or pool. Goes away on high speed and then I make sure to purge the filter, not much air in it though.
I have an above ground so no problems with priming, but I always have the little air bubble on low. And usually my PSI registers around 2-3 when on Low.
I see a lot of issues VSP pumps having air at a lower RPM. Would that also affect a 2 speed pump. it has an air bubble constantly at the top. I just replaced the motor on my duraglass with a 2 speed.
Hi pooly1 can you give me the specifics on your 2 speed motor and the cost? I have a 1.5 hp duraglass that I would like to eventually change to a 2 speed. Thanks
I have/had a duragals I pump with 3/4hp motor and had the motor replaced with a 2 speed 1 hp cost was 283.00 for the pump and an additional 30.00 to have them install the 2 seals(I did it last time and it was so of a bear to tap the ceramic seal on and seat it correctly. I went through the company below as I had a good experience with them previously. Also they do not come with the 2 speed switch just an FYI.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!