I have an old Chlormatic II (now Jandy Aquapure) which has been working for 10 years. I have replaced one of the boards and put in a new Aquapure Generator about 3 years ago.
I got the Service code 123 today which is low voltage to the cell. When I checked the DC cable at the cell, the the cord was melted around the middle pin and the pin is partially gone. I didn't realize there was enough voltage there to do this much damage.
My question is..would this damage my cell or fry one of the boards? I have enough pin left to make a decent connection if I replace the cable, but I'm worried about other damage.
Thanks for your help.
Greg
I got the Service code 123 today which is low voltage to the cell. When I checked the DC cable at the cell, the the cord was melted around the middle pin and the pin is partially gone. I didn't realize there was enough voltage there to do this much damage.
My question is..would this damage my cell or fry one of the boards? I have enough pin left to make a decent connection if I replace the cable, but I'm worried about other damage.
Thanks for your help.
Greg