No error codes from my AquaPure 1400, but a stubborn light stuck on "cell reversing" - and no chlorine production.
I replaced the cell with the new version PLC1400. Btw, do I need to use that flow sensor interface clip?
I put a voltimeter on the unit - transformer read right but no current from the back board to the cell. Current is moving through the transformer and not going to the cell, right?
So, I replaced the back board.
Still - "cell reversing" and no chlorine!! Flow light is on also. Read-out flashes percentage and EC (it's hooked up to my One Touch).
Jandy service was less than useful.
Any ideas, short of buying a APUREM box?
I replaced the cell with the new version PLC1400. Btw, do I need to use that flow sensor interface clip?
I put a voltimeter on the unit - transformer read right but no current from the back board to the cell. Current is moving through the transformer and not going to the cell, right?
So, I replaced the back board.
Still - "cell reversing" and no chlorine!! Flow light is on also. Read-out flashes percentage and EC (it's hooked up to my One Touch).
Jandy service was less than useful.
Any ideas, short of buying a APUREM box?