Well, I hooked my liquidator up last weekend. Wasn't able to do some testing until later in the week because it rained most of the week. I noticed that the bleach level was not going down. Well, CL level is 0 and remained 0 even when I tested the water directly from the return. There is water flow into and out of the liquidator because I can see it through the tubing. I have the same problem that Miranda had with the lack of flow through the liquidator with the skimmer valve completely open. I have both check valves on and the valve from the skimmer to the pump is only about 1/3 open. This gives me a flow rate of 3. Just can't figure out why it is not drawing any bleach.
Any suggestions?
Oh, I don't know if this is related or not, but the pump is on a timer and when the pump starts back up, the pressure on the filter gauge is 0 and stays 0.
Any suggestions?
Oh, I don't know if this is related or not, but the pump is on a timer and when the pump starts back up, the pressure on the filter gauge is 0 and stays 0.