HI EVERYONE,
by using this forum,i was able to change out the limiter on the panel of my SWG box,so firstly...thank you for all the info,the limiter was cracked.
i have a few questions about the readings.
1,the generating light is on(also the power) but the cell voltage is around 30.0
2,the current reads at 0.00 which it is suppose to read at that when it is not generating.
i have noticed that the current will adjust back to the 4.50 to 7.80 range now and then.
so my question is:
are these readings a problem?
should the limiter be hot after soldered back in place?
many thanks
by using this forum,i was able to change out the limiter on the panel of my SWG box,so firstly...thank you for all the info,the limiter was cracked.
i have a few questions about the readings.
1,the generating light is on(also the power) but the cell voltage is around 30.0
2,the current reads at 0.00 which it is suppose to read at that when it is not generating.
i have noticed that the current will adjust back to the 4.50 to 7.80 range now and then.
so my question is:
are these readings a problem?
should the limiter be hot after soldered back in place?
many thanks