Hooray! I got my IntelliChlor SWG hooked up yesterday, and I turned it on to make sure it worked. The ADD salt button was blinking, which I expected (the PB intentionally had me add too little salt so we could build up), but I noticed after awhile that the CELL light was blinking, which is supposed to indicate that I need to clean the cell.
The pool chemistry is off (0 FC, I did add chlorine this a.m.), and I know that I have less than 20 CYA. I did see in the manual that it says that I should never have less than 50 CYA level, so I put the SWG on 0%, afraid that if I leave it generating with the CELL light blinking that I may screw something up. BTW, my water temp is 69, so cold water shouldn't be a factor, I don't think.
Any ideas why the CELL light would be blinking? I am trying to add CYA asap, but it does take awhile to get through that darn sock.
The pool chemistry is off (0 FC, I did add chlorine this a.m.), and I know that I have less than 20 CYA. I did see in the manual that it says that I should never have less than 50 CYA level, so I put the SWG on 0%, afraid that if I leave it generating with the CELL light blinking that I may screw something up. BTW, my water temp is 69, so cold water shouldn't be a factor, I don't think.
Any ideas why the CELL light would be blinking? I am trying to add CYA asap, but it does take awhile to get through that darn sock.