- Jul 17, 2012
- 7
Apologize if this is in the wrong section...
Suddenly I am not receiving any power to my pump and I was hoping to get some ideas from the forum. I could not find anything after searching for a few nights.
I have an aqua logic control board. A few months ago I received the No Cell Power message and through this board, found the solder fix. It worked. Not too long after that I had to replace the pump.
Yesterday, the pump stopped working again. I checked the circuit breakers and nothing was tripped. I cycled anyway and nothing. I am not getting the No Cell Power message. If I unplug the cell cord, the yellow light on the control board interface does come on and it goes off when I plug the cell plug back in. The pool lights still work.
I had the installer of the pump come back out and there is no power to the pump itself. This is not a case where it is getting power and not starting. It literally is not receiving power.
Could this be the same solder/relay problem as before even though I am not getting the No Cell Power message?
Any ideas or similar experiences before I drop the cash for a new circuit board?
Thanks in advance!
Suddenly I am not receiving any power to my pump and I was hoping to get some ideas from the forum. I could not find anything after searching for a few nights.
I have an aqua logic control board. A few months ago I received the No Cell Power message and through this board, found the solder fix. It worked. Not too long after that I had to replace the pump.
Yesterday, the pump stopped working again. I checked the circuit breakers and nothing was tripped. I cycled anyway and nothing. I am not getting the No Cell Power message. If I unplug the cell cord, the yellow light on the control board interface does come on and it goes off when I plug the cell plug back in. The pool lights still work.
I had the installer of the pump come back out and there is no power to the pump itself. This is not a case where it is getting power and not starting. It literally is not receiving power.
Could this be the same solder/relay problem as before even though I am not getting the No Cell Power message?
Any ideas or similar experiences before I drop the cash for a new circuit board?
Thanks in advance!