- Jul 3, 2012
- 2
Hi everyone! I just set up an Intex 20x48 ultra frame that holds 8000 gallons. I added a through the wall wide mouth skimmer, and a bigger pump and filter that flow tested just over 3000 gpm after it was plumbed in. It also has an Intex swg. I just tested my fill water from my well and got these numbers:
Ph- 7.8
Alk- 250
Ch- 1180
I'm kinda clueless and don't know what I should do. I'm worried about the ch.
Im out in the boonies and can't get loads of softer water delivered. I remember reading somewhere I could raise the ph to over 10 to precipitate the calcium then vacuum it out.
Could anyone give me an idea of where to start, desired levels, what chemicals to use, how many bags of salt, ect?
Thanks
Ph- 7.8
Alk- 250
Ch- 1180
I'm kinda clueless and don't know what I should do. I'm worried about the ch.
Im out in the boonies and can't get loads of softer water delivered. I remember reading somewhere I could raise the ph to over 10 to precipitate the calcium then vacuum it out.
Could anyone give me an idea of where to start, desired levels, what chemicals to use, how many bags of salt, ect?
Thanks