- Dec 9, 2011
- 8
My Goldline Turbo Cell chlorine generator is not working. The salt display on the control box has been stuck at 2400 (even after adding 3 bags and checking that salt is at 3500 using a titration test kit) for weeks/months.
The Goldline control box has Power and Aqualink RS LEDs lit solid green, but it never shows "Generating". Also, none of my control panels (All Button, One Touch) show the salt level display any more either. The All Button used to show "Salt xxxx" when the filter pump was running, but not now. It appears that the system doesn't really know that the CLcell is attached.
I needed to clear my Jandy RS6 system memory a while back due to a Spalink problem. I'm guessing that the memory clear/reset wiped out some setting someplace for the CL generator.
When cycling through the display on the cell box I see these:
2400
86
33.2
0.00
OP
-0
r1.09
Anyone have any ideas?
Thanks,
Bruce
The Goldline control box has Power and Aqualink RS LEDs lit solid green, but it never shows "Generating". Also, none of my control panels (All Button, One Touch) show the salt level display any more either. The All Button used to show "Salt xxxx" when the filter pump was running, but not now. It appears that the system doesn't really know that the CLcell is attached.
I needed to clear my Jandy RS6 system memory a while back due to a Spalink problem. I'm guessing that the memory clear/reset wiped out some setting someplace for the CL generator.
When cycling through the display on the cell box I see these:
2400
86
33.2
0.00
OP
-0
r1.09
Anyone have any ideas?
Thanks,
Bruce