Hello all. Nubee here, I have an in ground pool that had a Hayward single speed 115vac pump on it. The pump was seized up, wouldn’t spin. I decided for a nice energy saving 2 speed pump AO smith STS1152R . I ran new wire and conduit 10/3 on a 30 amp breaker. Put in a disconnect switch made for outdoor use. I took the rear canopy cover off the back of the motor to wire it up and Hmmmmm I’m lost. In doing hours of research, I have found out that I can either get an external switch or buy a new canopy cover with a switch built in. been looking at all the wiring diagrams and still lost. I cannot get either option till after Memorial Day weekend as everyone is closed. What is the best way to do this job as I would like to tie in a timer to run the pump for a few hours 3 times a day, at a later time? Is there any way to run this pump on one speed temporarily so I can de-frog my pool? With the use of algae killer and manually stirring 30,000 gallons of water, I have turned it from swamp green to a pretty shade of milky light green. This pool was unattended for 3 years. I pulled as much debris as I could, off the bottom of the pool (3 day job) and drained 75% of the water and filled with tap water. Any and all help would be greatly appreciated as I do not want to fry a brand new $350.00 pump motor.