My wife and I recently purchased our house last year with a built-in pool/spa that is approximately 12,000 gallons. After using chlorine all last summer, we decided to try to get the SWG running (which was already installed).
After plugging everything in and turning it on, I had a steady "no flow" light, so I replaced the flow sensor. After replacing the flow sensor, it seemed to be working for about a day. My salt reading was at 2600 (which may or may not have been correct). I proceeded to adding 40 lbs. of pool salt to start working towards 3200. However, yesterday, when I turned the pump on to check the status, the salt reading was 300 and the "inspect cell" light was on.
Here are the current readings:
Power light: "ON"
Generating: "OFF"
Low Salt: "ON"
Inspect Cell: "ON"
Salt: 100 (down from 300 yesterday)
Temp: 77
Voltage: 31.9
Current: 0.00
Output: 19P
Instant Salinity: - 0
Product: AL - 0
Version: r1.10
I have taken apart the salt cell and cleaned it with a muriatic acid mix, and still have the same result. I have also borrowed a relatively new cell from a neighbor with the exact same model and installed it with the same result.
The salt cell is a T-Cell-15 and an Aqua Rite generation system.
Any ideas???
Thanks in advance!
After plugging everything in and turning it on, I had a steady "no flow" light, so I replaced the flow sensor. After replacing the flow sensor, it seemed to be working for about a day. My salt reading was at 2600 (which may or may not have been correct). I proceeded to adding 40 lbs. of pool salt to start working towards 3200. However, yesterday, when I turned the pump on to check the status, the salt reading was 300 and the "inspect cell" light was on.
Here are the current readings:
Power light: "ON"
Generating: "OFF"
Low Salt: "ON"
Inspect Cell: "ON"
Salt: 100 (down from 300 yesterday)
Temp: 77
Voltage: 31.9
Current: 0.00
Output: 19P
Instant Salinity: - 0
Product: AL - 0
Version: r1.10
I have taken apart the salt cell and cleaned it with a muriatic acid mix, and still have the same result. I have also borrowed a relatively new cell from a neighbor with the exact same model and installed it with the same result.
The salt cell is a T-Cell-15 and an Aqua Rite generation system.
Any ideas???
Thanks in advance!