I just purchased a liquidator from Sal and it is on its way. I would like to know where I can source the nylon 3/8 x 1/4 NPT fittings so I can install the out and in lines in my pump and heater drains, versus drilling. Anyone?
Sal sells the kit with the 3/8" upgrade (thanks), but is replacing the flow control needle valve necessary? If so, where can I source the one recommended on this board.
Thanks in advance! This forum has been a wealth of knowledge and assistance.
I have a 14000 gallon pool that was installed last year here in Vegas. Currently running a rainbow chlorinator with trichlor pucks that already have my CH at 660! (I know a partial drain is in order) and CYA at 70 and rising!
Sal sells the kit with the 3/8" upgrade (thanks), but is replacing the flow control needle valve necessary? If so, where can I source the one recommended on this board.
Thanks in advance! This forum has been a wealth of knowledge and assistance.
I have a 14000 gallon pool that was installed last year here in Vegas. Currently running a rainbow chlorinator with trichlor pucks that already have my CH at 660! (I know a partial drain is in order) and CYA at 70 and rising!